Copper Slag 30/60, 4,000lb super tote sacks.

• 30/60 will provide a 2.0 to 2.5 mils profile when blasted at 90-100 psi, with a 45 to 90 degree angle, 18-24" distance to Surface.
• 30/60 grit cannot be reclaimed, it is just too fine.
• A 3.0 mils profile is possible with 30/60 but only on new steel without any coating.
• Copper slag is a hard, cubical, and aggressive sandblasting media. Independent studies have shown it to be the fastest cutting slag abrasive.
• You must have a forklift at the end destination to unload the flatbed.
• Listed on Naval QPL-22262.  Excellent for drydocks and shipyard blasting.
• Enviromentally friendly.
• Water Quenched (not air dried).  Angular and Aggressive.
• Blastox additive is available, please ask us for pricing and lead times.
• Approved for recycling in Portland cement.
• Best abrasive to use when ranked on cutting speed and cost per sq. ft., according to independent NIOSH tests.
• Both arsenic and lead testing is done to the material and is therefore on the United States Naval Qualified Products list.
• California Air Resources Board (CARB) approved for dry outdoor abrasive blasting.

Freight:

• Please email us for a custom freight quotation on this material.
• Packaging: Bulk (loose), 2 ton supersacks, or 75 lb bags.
• Sold by the truckload only.
• 24 net tons, packaged in 4,000lb super tote bags. 12 pallets/load.
• Pallet charges will also apply. Shrinkwrapping is available at an additional charge.
• Priced per net ton, or per 2,000lbs.
• Shipped via flatbed only.
• Contact us for multiple truckload prices!

Aggregate Properties:

• Fractured Faces:  100%
• Sand Equivalent:  91%  (Extremely clean, no ash, clay, contaminants)
• LA Wear:  4% Loss